Standing seam
Concealed fasteners and raised seams give a clean, modern look with no screws through the panel face. It is the premium option and needs the least upkeep.
New homes · Additions
Metal Roof Installation Beaumont TX
Building a new home or adding on? We install standing seam and exposed-fastener metal roofs as a complete system, from the underlayment and flashing to the last piece of trim.
✓Written project scope
✓Standing seam or exposed fastener
✓Material and workmanship warranties
Built from the deck up
Beaumont Metal Roof Installation
A metal roof is only as good as the way it goes on. On new construction and additions, we start from the bare deck, so every layer is planned: underlayment, eave and rake trim, valley and wall flashing, panels, and ridge. There is no old roof to remove and nothing to work around.
We install on new homes and on additions to existing homes. On an addition, the new roof has to tie into the existing one cleanly. That joint is a common leak point, so it gets the most attention.
Replacing an old roof instead? See our metal roof replacement page. For everything else we do, start with our metal roofing in Beaumont overview.
Choosing your system
Picking the right metal roof
Four decisions shape how the roof looks, what it costs, and how much care it needs over the years.
Exposed fastener
Screws with sealing washers hold the panels through the face. It is the budget-friendly option and a good fit for many homes, with periodic checks on the screws and washers.
Panel gauge
A lower gauge number means thicker steel. Thicker panels resist dents better and cost more; we will explain which gauge makes sense for your roof.
Color and finish
Lighter colors reflect more of the summer sun. Panel color and trim are picked together so the whole roof looks finished.
On the job
How we install a metal roof
Every installation follows the same order, because each layer protects the one under it:
When the roof is done, we walk it with you and hand over the warranty paperwork.
Underlayment
The deck is covered with underlayment first, with extra protection in valleys and along the eaves.
Trim and flashing
Eave, rake, valley, and wall flashing go on before the panels, so water always runs over a seam, never into one.
Panels to a layout
Panels are set to a planned layout so seams run straight and cut pieces stay at the edges.
Ridge and closures
Ridge caps and closure strips seal the top of the roof against wind-driven rain and pests.
Before you call
Installation questions
Do you install metal roofs on new construction?
Yes. We install metal roofs on new homes and on additions to existing homes.
Which is better, standing seam or exposed fastener?
Neither is better for every home. Standing seam costs more and needs less upkeep; exposed fastener costs less and needs its screws and washers checked over time. We will walk you through both for your roof.
Can a new addition match my existing roof?
If your existing roof is metal, we match the panel profile and color as closely as is available. If it is shingle, the joint between the two roofs gets its own flashing detail.
How do I get started?
Call (409) 234-5007. Tell us about the project and we will give you a written scope with your options.
Service area
Where we install
We install metal roofs across Beaumont and in nearby Bevil Oaks.
Start your project
Planning a new roof?
Tell us about the home or addition and what you want from the roof. We will explain your options and give you a written scope.